admin:3dprinter
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
admin:3dprinter [2019/05/28 20:45] peppe |
admin:3dprinter [2022/09/20 11:23] (current) peppe |
||
|---|---|---|---|
| Line 2: | Line 2: | ||
| ==== Nozzle ==== | ==== Nozzle ==== | ||
| - | 0.5mm dia | + | 0.6mm dia |
| ==== Print volume ==== | ==== Print volume ==== | ||
| - | 200x200x200mm | + | 200 x 200 x 200 mm |
| ==== Filament ==== | ==== Filament ==== | ||
| {{tablelayout? | {{tablelayout? | ||
| - | ^ Filament | + | ^ Filament |
| - | | PLA | 65 | | + | | PLA | 65 | 1,24 g/cm3 | |
| - | | PETG | 85 | | + | | PETG | 85 | ≥1,29 g/cm3 | |
| - | | ABS | 110 | | + | | ABS | 110 |
| ==== Software ==== | ==== Software ==== | ||
| - | - Klipper | + | * [[https:// |
| - | - Octoprint | + | * [[https:// |
admin/3dprinter.1559065511.txt.gz · Last modified: 2019/05/28 20:45 by peppe
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
